1.1 This test method covers the evaluation of the oxidation stability of inhibited steam-turbine oils in the presence of oxygen, water, and copper and iron metals at an elevated temperature. This test method is limited to a maximum testing time of 10 000 h. This test method is also used for testing other oils, such […]

1.1 This specification covers formulating specifications for purchases of aviation gasoline under contract and is intended primarily for use by purchasing agencies. 1.2 This specification defines specific types of aviation gasolines for civil use. It does not include all gasolines satisfactory for reciprocating aviation engines. Certain equip-ment or conditions of use may permit a wider,

1.1 This terminology standard is a compilation of defini-tions used in the science and technology of the adhesives industry. Terms that are generally understood or adequately defined in other readily available sources are not included. 1.2 Any changes in this standard since 1988 are documented as follows: 1.2.1 Appendix X1 gives a history of revisions

1.1 This test method covers the determination of the gas content of electrical insulating oils of low and medium viscosities in the general range up to 190 mm 2 /s at 104°F [40°C], such as are used in capacitors and paper-insulated electric cables and cable systems of the oil-filled type. The determination of gas content

1.1 This practice, 3,4 known as the embrittlement-detector method, covers the apparatus and procedure for determining the embrittling or nonembrittling characteristics ofthe water in an operating boiler. The interpretation of the results shall be restricted to the limits set forth in 8.6. N OTE 1—Cracks in a specimen after being subjected to this test indicate

1.1 These test methods cover the test procedures to be applied to whole tall oils or refined tall oils. Previous editions of these test methods have described test procedures that are used to test tall oil fatty acid, rosin, and other tall oil-derived products as well as test crude and refined tall oil. Consequently, these

1.1 This specification covers the pigments commercially known as raw umber and burnt umber. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.1 This test method covers the determination of oil in petroleum waxes having a congealing point of 30 °C (86 °F) or higher as determined in accordance with Test Method D938,and containing not more than 15 % of oil.2 NOTE 1- With some types of waxes, of oil contents greater than 5 %，there may be

1.1 These test methods cover the analysis of aluminum silicate pigment. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.