ISO Standards

This document defines the terms used in ultrasonic non-destructive testing and forms a common basis for standards and general use. This document does not cover terms used in ultrasonic testing with phased arrays. NOTE Terms for phased array ultrasonic testing are defined in EN 16018.

ISO 5856:2008 specifies the dimensions of 100° normal countersunk head screws with internal offset cruciform ribbed or unribbed drive, with close or large tolerance normal shank and short or medium length MJ threads, in metallic material, coated or uncoated, with strength classes less than or equal to 1 100 MPa. This International Standard is applicable

This part of IS0 5667 provides guidance on the selection and use of various quality assurance and quality control techniques relating to the manual sampling of surface, potable, waste, marine and ground waters. NOTE The general principles outlined in this part of IS0 5667 might, in some circumstances, be applicable to sludge and sediment sampling.

This document specifies a method for the determination of bending stiffness using the resonance method. This method gives only a single result for each test piece tested, although in general, bending stiffness values may depend on which surface of the material forms the inner surface of the arc resulting from bending forces.

This document specifies two methods for determining the adhesion strength of vulcanized rubber to wire cord which is embedded in the rubber. The two methods do not necessarily give the same results.

ISO 4647:2010 specifies a method for the determination of the static adhesion of textile cord to vulcanized rubber using the H-pull test. It is applicable to cords made from natural or man-made fibres. The property levels obtained with this method are affected considerably by the history of the cord and the rubber compound. The method

ISO 4641:2010 specifies the minimum requirements for textile-reinforced, smooth-bore rubber water-suction and discharge hoses and hose assemblies. Three types of hoses and hose assemblies are specified according to their operating duty requirements, i.e.their ambient and water temperature ranges: ⎯ ambient temperatures: −25 °C to +70 °C; ⎯ water temperatures during operation: 0 °C to +70

ISO 4633:2015 specifies requirements for materials used in vulcanized rubber seals for the following: a) cold drinking-water supplies (up to 50 °C); b) drainage, sewerage, and rainwater systems (continuous flow up to 45 °C and intermittent flow up to 95 °C).

ISO 4611:2008 specifies the conditions of exposure of plastics to ⎯ damp heat; ⎯ water spray; ⎯ salt mist; and the methods for the evaluation of the change in some significant characteristics after given exposure stages.