ISO Standards

ISO 11591:2020 outlines the requirements for the field of vision from the steering position, both forward (horizontally and vertically) and astern, for small craft with a hull length (L H) of up to 24 meters, in accordance with ISO 8666:2016.

ISO 11591:2019 establishes the requirements for the field of vision from the steering position, both forward (horizontally and vertically) and astern, for small craft with a hull length (L H) of up to 24 meters, in accordance with ISO 8666.

ISO 11540:2021 outlines the requirements to minimize the risk of suffocation from caps for writing and marking tools. It specifically addresses tools that are likely to be used by children up to the age of 14 years, as well as tools designed or intended solely for adult use, such as jewelry pens, expensive fountain pens,

ISO 11484:2019 outlines a qualification system established by employers for non-destructive testing (NDT) personnel responsible for testing the following types of steel products: a) Tubes and pipes (both seamless and welded); b) Flat products, long products, rails, bars, sections, rods, and wires. It specifies the qualification requirements necessary for Level 1 and Level 2 NDT

ISO 11443:2021 outlines methods for assessing the fluidity of plastic melts subjected to shear stresses at rates and temperatures that approximate those encountered in plastic processing. The importance of testing plastic melts according to these methods is underscored, as the fluidity of plastic melts is not solely determined by temperature but also influenced by other

The present document details a dynamic impact wedge technique for evaluating the cleavage resistance of high-strength adhesive joints between two substrates under impact loading, as per defined preparation and testing conditions. It is important to note that this testing procedure does not yield design-related data. This method facilitates the selection between sheet metal or fiber-reinforced

ISO 11132:2021 provides guidelines for evaluating the overall performance of a quantitative descriptive panel as well as the performance of individual panel members. It is relevant for validating the training of both individual assessors and panels, in addition to monitoring the performance of established panels. However, it does not apply to panel performance in descriptive

ISO 11105:2020 outlines the ventilation requirements for petrol engine and petrol tank compartments in small crafts that use petrol engines for propulsion, electrical generation, or mechanical power. Its purpose is to prevent the buildup of explosive gases in these areas. Note that personal watercraft are excluded from this document.

ISO 4045:2018 outlines a procedure for measuring the pH level and the differential figure of an aqueous extract from leather. It is suitable for all varieties of leather.

ISO 1161:2016 establishes the basic dimensions and the functional and strength requirements of corner and intermediate fittings for series 1 freight containers, i.e. containers which conform to ISO 668 and ISO 1496 (all parts) with the exception of air mode containers (see ISO 8323).