IEEE Standards

This standard establishes uniform procedurcs for the measurement of power frequency electric and magnetic fields from altermnating current (ac) overhead power lines and for the calibration of the meters used in these measurements. A uniform procedure is a prerequisite to comparisons of electric and magnetic fields of various ac overhead power lines. These procedures apply […]

This standard contains the requirements for the design, insallation, and qualification of raceway systems for Class IE circuits extermal to electric equipment and components for nuclear power generating stations.Because aging and radiation have no known detrimental effects on metallic raceway systems and because nonmetallic raceway systems are limnited to underground or embedded applications, aging and

This standard provides a source of defintions of terminology used in the development, manufacture, and test of inerial instruments used for navigation, guidance, orientation, stabilization, and related applications.This is a companion document to IEEE Std 1559TM.

Since World War II, radar systems engineers have used band letter designations as a short notation for describing the frequency band of operation. This usage has continued throughout the years and is now an accepted practice of radar engineers. Radar-frequency letter designations are used for the following reasons: — They provide a convenient method for

Methods are described for defining the dc load and for sizing a lead-acid battery to supply that load for stationary battery applications in float service. Some factors relating to cell selection are provided for consideration. Installation, maintenance, qualification, testing procedures, and consideration of battery types other than lead acid are beyond the scope of this

This recommended practice provides recommended design practices and procedures for storage,location, mounting, ventilation, instrumentation, preassembly, assembly, and charging of vented lead-acid batteries. Required safety practices are also included. This recommended practice is applicable to full-float stationary applications where a battery charger normally maintains the battery fully charged and supplies provides the direct current (dc) loads.

This standard establishes critria for qualfication of safety-related actuators, and actuator components, in Nuclear Power Generating Stations and other Nuclear Facilities in order to demonstrate their ability to perform their intended safety functions.

The scope of the project is to cover measurements of the electrical properties of naturally occurring solids.Not covered are methods that rely on mapping earth structure anomalies unless directly related to electrical properties. There is limited coverage of numerical methods for forward/inverse modeling.

This standard provides techniques for objective measurement of electroacoustic devices used for speech communications, including communication devices also used for multimedia applications. Application is for devices that are primarily used closely coupled to the ear. Aspects of devices with speakerphone or speaker listening features are covered by IEEE Std 1329™. 1 This standard is applicable