ASTM Standards

1.1 This specification establishes requiremnents for chemi-cally blown cellular rubber. 1.2 In the case of confict between the provisions of this specification and those of detailed specifcaions or test meth-ods for a particular product, the latter shall take precedence. 1.3 Unless specifially stated otherwise, by agreement be-tween the purchaser and the supplier, all test methods […]

1.1 This test method covers the corrosiveness of hydraulic and lubricating fluids to a bimetallic galvanic couple. NOTE 1—This test method replicates Fed-Std No. 791, Method 5322.2.It utilizes the same apparatus, test conditions, and evaluation criteria, but it describes test procedures more explicitly. 1.2 The values stated in SI units are to be regarded as

1.1 This guide provides techniques to be used for the evaluation of the measurement performance of on-line coal analyzers. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility ofthe user of this standard to establish appro-priate safety and health practices and

1.1 This specification covers the requirements for HFC-236fa as a fire-fighting medium. 1.2 This specification does not address the fire-fighting equipment or hardware that employs HFC-236fa or the condi-tions of employing such equipment (for example, hand-helds,fixed installations, and so forth).

1.1 This test method covers the determination technique for a dip tube of a mechanical pump dispenser. 1.2 The values stated in both inch pound and SI units are to be regarded separately as the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use.

1.1 This test method covers the determination of the peak force-to-actuate, sometimes called force-to-actuate (FTA), of a mechanical pump dispenser. 1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.

1.1 This test method covers the determination of the hy-draulic conductivity, or the permeability relative to water, ofany porous medium in the laboratory, in particular, the hydrau-lic conductivity for water in subsurface materials, for example,soil, sediment, rock, concrete, and ceramic, either natural orartificial, especially in relatively impermeable materials ormaterials under highly unsaturated conditions. This testmethod

1.1 This practice presents sample collection and statistical evaluation procedures for testing mechanical sampling sys-lems, subsystems, and individual system components for bias.It is the responsibility of the user of this practice to select the appropriate procedure for a specific sampling situation. 1.2 This practice does not purport to define an absolute bias.Bias defined by this

1.1 This guide covers methods for field preservation of ground-water samples. Laboratory preservation methods are not described in this guide. 1.2 This standard may involve hazardous materials, opera-tions, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user

1.1 This practice establishes orientation codes for continuous-fiber-reinforced composite materials. Orientation codes are explicitly provided for two-dimensional laminates and braids. The laminate code may also be used for filament-wound materials. A method is included for presenting subscript information in computerized formats that do not permit sub-script notation. 1.2 This standard does not purport to address