ASTM Standards

1.1 This practice covers flow conditioners that produce a fully developed flow profile for liquid and gas phase fluid flow for circular duct sizes 1- to 60-in. (25.4- to 1525-mm) diameter and Reynolds Number (Re) ranges from transition (100) to 100 000 000. These flow conditioners can be used for any type of flow meter […]

1.1 This practice covers the determination of the perfor-mance of oxygen removal ion exchange resin cartridges in the regenerated form when used for removing dissolved oxygen from water. The test can be used to determine the initial capacity ofunused cartridges or the remaining capacity ofused cartridges. In this case, performance is defined as oxygen removal

1.1 This practice is intended to cover the extraction,analysis, and information management pertaining to visible wear debris collected from oil system filters or debris retention screens. Further, it is intended that this practice be a practical reference for those involved in FDA. 1.2 The values stated in SI units are to be regarded as standard.

1.1 This test method covers determination of engine coolant corrosion protection and stability under accelerated thermal and oxidizing conditions using a rotary pressure vessel. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses after SI units are provided for information only and are not considered

1.1 This laboratory practice covers the quantitative determi-nation of surface deposits produced during the thermal oxida-tion of gas turbine fuels by monitoring the oscillation fre-quency of a quartz crystal during thermal exposure. In this practice, “thermal oxidative stability” refers to the tendency of a fuel to resist surface deposit formation during heating. 1.2 The values

1.1 This guide covers the classification and reporting of results from in-service lubricant particulate debris analysis obtained by microscopic inspection of wear and contaminant particles extracted from in-service lubricant and hydraulic oil samples. This guide suggests standardized terminology to promote consistent reporting, provides logical framework to document likely or possible root causes, and supports inference

1.1 This test method covers the instrumental determination of sulfur content in samples of carbon black feedstock oils.Values obtained represent the total sulfur content. Two analysis methods are available for use: Test Method A: High-Temperature Combustion With Infrared Absorption Detection Procedures Sections 4 – 10 Test Method B: X-Ray Fluorescence Sections 13 – 17

1.1 This practice stipulates the types, names, and sizes of Codes for those material types specified in Table 1. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are likely not to be exact equivalents; therefore, each system shall be

1.1 This test method covers the determination of dimen-sional changes in the lengthwise and width-wise direction and distortion likely to occur when pile floor coverings are exposed to various conditions of moisture and heat. This method is applicable to all pile floor coverings including carpet module form. 1.2 This method is applicable to machine made

1.1 This test method covers the determination of total nonaromatic hydrocarbons and monocyclic aromatic hydrocar-bons in benzene, toluene, ethylbenzene, p-xylene, o-xylene, styrene and mixed xylenes by gas chromatography. The purity of benzene, toluene, ethylbenzene, p-xylene, o-xylene, styrene and mixed xylenes is also calculated. Similar test methods,using the internal standard calibration technique and the external standard