ASTM Standards

1.1 This test method describes the measurement of the number of binding sites per unit length or width of machine-made, woven, knitted, and tufted pile yarn floor covering both before and after adhesive backing application. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical […]

1.1 This practice identifies design and construction consid-erations to be applied to monitoring wells for protection from natural and man caused damage or impacts. 1.2 The installation and development of a well is a costly and detailed activity with the goal of providing representative samples and data throughout the design life of the well.Damages to

1.1 This guide covers how hollow-stem auger-drilling sys-tems may be used for geoenvironmental exploration and installation of subsurface water-quality monitoring devices. 1.2 Hollow-stem auger drilling for geoenvironmental explo-ration and monitoring device installations often involves safety planning, administration, and documentation. This guide does not purport to specifically address exploration and site safety.

1.1 This test method determines the amount of bromine-reactive material in aromatic hydrocarbons and is thus a measure oftrace amounts ofunsaturates in these materials. It is applicable to materials having bromine indexes below 500.

1.1 These test methods for chemical analysis ofextractables from synthetic rubbers are intended for general use on solid uncompounded styrene-butadiene copolymers commonly re-ferred to as SBR. Analysis of other synthetic rubbers is also possible with some ofthese test methods. The test methods and the sections in which they are covered are as follows:

1.1 This specification covers performance levels for adhe-sives to be used in laminate joints in nonstructural lumber products. Such products include, but are not limited to, interior and exterior mouldings, window and door components or parts,and bonded lumber panels. This specification is to be used to evaluate adhesives as well as the adhesive bonds in

1.1 This test method determines the resistance of a stretch wrap film to the penetration of a probe at a standard low rate,a single test velocity. Performed at standard conditions, the test method imparts a biaxial stress that is representative ofthe type of stress encountered in many product end-use applications.The maximum force, force at break,

1.1 This practice covers a method for characterizing surface wind speed, wind direction, peak one-minute speeds, peak three-second and peak one-minute speeds, and standard devia-tions of fluctuation about the means of speed and direction. 1.2 This practice may be used with other kinds of sensors if the response characteristics of the sensors, including their signal

1.1 This specification covers mineral-colloid-stabilized,concentrated, emulsified, refined coal tar suitable for use as weather-protective and aliphatic-solvent resistant coatings over bituminous pavements such as those found at airports, parking areas, and driveways. The specification for this material was previously covered by Federal Specification RP355. N OTE 1—Dilute the concentrated emulsion after testing and prior to application

1.1 This practice covers techniques to accelerate weathering effects of factory-coated embossed hardboard using apparatus described in Practice G 90. 1.2 This practice is based upon Procedure B, Cycle 1 of Practice G 90 (concentrated natural sunlight with periodic surface water spray) plus a soak-freeze-thaw cycle (see 5 of this practice).