ASTM Standards

1.1 This test method covers the specific determination ofthe effect of short-radius bends on coatings applied to 33.4-mm (1-in. nominal) diameter pipe. 1.2 The values stated in SI units to three significant deci-mals are to be regarded as the standard. The values given in parentheses are for information only.

1.1 This method covers the determination of the apparent rate of depth of water penetration into insulating coatings applied to pipe. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.1 These test methods cover accelerated procedures for simultaneously determining comparative characteristics of in-sulating coating systems applied to steel pipe exterior for the purpose of preventing or mitigating corrosion that may occur in underground service where the pipe will be in contact with inland soils and may or may not receive cathodic protection.They are intended

1.1 This test method covers an experimental procedure for checking experimental technique and instrumentation. If followed, this test method will provide repeatable potentiody-namic anodic polarization measurements that will reproduce data determined by others at other times and in other labora-tories provided all laboratories are testing reference samples from the same lot of Type 430 stainless

1.1 This practice covers coaventions for reporing and displaying eletrochemical corrosion data. Conventions for poiential, current densily, electrochemical impedance and admitance, 8as well 8 conventions for graphical presentation of such data ane incluxded.

1.1 This practice covers conventions for reporting and displaying electrochemical corrosion data. Conventions for potential, current density, electrochemical impedance and admittance, as well as conventions for graphical presentation of such data are included.