ASTM Standards

1.1 This test method covers the double shear testing of aluminum and aluminum alloy rivets with round, solid shanks and cold-heading wire and rod.2 NoreE 1- Exeptons to this test method may be ncesary in individuall specifications or methods for tests for a particular material.

1.1.2 Nickel-iron-chromium-tungsten alloy UNS N06674 is normally employed in service temperatures above 1 100°F (593°C) where resistance to creep and rupture is required, and is annealed to develop optimum properties in this temperature range.

1.1 These test methods cover the tension testing of wrought and cast aluminum- and magnesium-alloy products, with the exception of aluminum foil, 2 and are derived from Test Methods E8, which cover the tension testing of all metallic materials. 1.2 The values stated in inch-pound units are to be regarded as standard. No other units

1.1 This test method specifies a method for the determina-tion of tap density (packed density) of metal powders and compounds, that is, the density of a powder that has been tapped, to settle contents, in a container under specified conditions.

1.1 This specification2 covers welded, cold-worked, and annealed nickel- chromium- iron alloy (UNS N06600,3 N06603,N06025, and N06045) pipe for general corrosive service and heat-resiting applications. 1.2 This specification covers outside diameter and nominal wall pipe shown in ANSI B36. 19. Pipe having other dimen-sions may be furnished provided such pipe complies with all other requirements

1.1 This specification covers silver- coated, round, copper-clad steel wire for electronic application. 1.2 Silver coatings in mass percentages of the total mass of the coated wire are as follows: 1.25, 2.5, 4.0, 6.1, and 8.0.

1.1 This spcification2 covers three grades of zirconium and zirconium alloy forgings (see 4.1). 1.2 The values stated in either SI units or inch- pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining

1.1 This specification establishes the requirements for welded copper-nickel alloy pipe for general engineering pur-poses. The following alloys are covered:2

1.1 This spcifcation establishes the requirements for plate of a carbon steel or lowalloy steel base to which is integrally and continuously bonded on one or both sides a layer of copper or copper-base alloy. The material is generally intended for pressure vessel use but may be used in other structural applications where corrosion resistance

1.1 This secification establishes requirements for lloys whose copper alloy numbers and nominal compositions are shown in Table 1. The castings may be furmished as one of three types: static chill, centrifugal chill, or sand cast. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are