ASTM Standards

1.1 This practice was developed for electric-arc furnace graphite electrodes, and covers a procedure and equipment for obtaining core samples from electrodes in a manner that does not destroy the electrode nor prevent its subsequent use as originally intended. However, the minimum clectrode diameter, for which extraction of a core sample using this practice does […]

1.1 This test method covers two test procedures (A and B) for the determination of the compressive strength of fired whiteware materials. 1.2 Procedure A is generally applicable to whiteware prod-ucts of low- to moderately high-strength levels (up to 150 000 psi or 1030 MPa).

1.1 This test method covers procedures for determining the stress-optical coefficient of glass, which is used in photoelastic analyses. In Procedure A the optical retardation is determined for a glass fiber subjected to uniaxial tension. In Procedure B the optical retardation is determined for a beam of glass of rectangular cross section when subjected to

1.1 These test methods cover or give reference to proce-dures for subsampling and for chemical, mass spectrometric,spectrochemical, nuclear, and radiochemical analysis of ura-nium hexafluoride (UF). Most of these test methods are in routine use to determine conformance to UF。specifications in the Enrichment and Conversion Facilities.

1.1 These test methods cover procedures for the chemical and spectrochemical analysis of nuclear grade silver-indium-cadmium (Ag-In-Cd) alloys to determine compliance with specifications.

1.1 This specification covers the minimum requirements for the installation of interior nonstructural steel framing and furring members designed to receive screw-attached gypsum panel products. The steel framing and furring members cov-ered in this specification are limited to those complying with Specification C645.

1.1 This test method covers the lesting of carbon and graphite in tension to obtain the tensile stress-strain behavior,to failure, from which the ultimate strength, the strain to falure, and the clastic moduli may be calculated as may be required for engineering applications. Table 2 lists suggested sizes of specimens that can be used in

1.1 This test method covers the precise determination of lead and cadmium extracted by acetic acid from glazed ceramic surfaces. The procedure of extraction may be expected to accelerate the release of lead from the glaze and to serve,therefore, as a severe test that is unlikely to be matched under the actual conditions of usage

1.1 This test method covers qualitative determination of the acid resistance of ceramic decorations on retumable beer and beverage containers, to assure the nccessary durability of the decoration. 1.2 This test provides an indication of performance when and if the decoration is to be exposed to the acid solutions used in reclaiming botles, and it

1.1 This test method covers a laboratory procedure for the determination of low-temperature flexibility of latex sealants after 500 h artilicial weathering. 1.2 The values stated in metrie (SD) units are to be regarded as the standard. The values given in parentheses are for information only.