ASTM Standards

1.1 These test methods cover the determination of the quantity of oxygen that certain impurities in water will consume, based on the reduction of a dichromate solution under specified conditions. The following test methods are included: Test Method A — Macro COD by Reflux Digestion and Titration Test Method B — Micro COD by Sealed […]

1.1 These test methods cover the determination of wet film thickness of organic coatings such as paint, varnish, and lacquer. Two methods are described as follows: 1.1.1 In Test Method A, the Wet Film Thickness Gage (English or Metric graduation (see 5.1)) is used to measure wet film thicknesses up to 60 mils on the

1.1 This test method covers the measurement of changes in linear dimensions of nonrigid thermoplastic sheeting or film that result from exposure of the material to specified conditions of elevated temperature and time.

1.1 This specification covers two types of high-content calcium carbonate pigments, as follows: 1.1.1 Type PC—Calcium carbonate precipitate, prepared either by complete solution or by carbonation of lime. 1.1.2 Type GC—Ground mineral product.

1.1 This standard covers a repository of terms and classifi-cations for the business of Subcommittee D07.03. 1.2 The terms in this standard pertain to processing and characteristics of wood veneer, plywood, and wood structural panels.

1.1 This test method covers the determination of volume resistivity of rubbers used in electrically conductive and antistatic products. 1.2 This test method assumes that the surface conductivity is negligible compared with the conductivity through the specimen.

1.1 This specifcation covers seven grades of diesel fuel suitable for various types of diesel engines. These grades are described as follows: 1.1.1 Grade No. 1-D SI5- A special-purpose, light middle distillate fuel for use in diesel engine applications requiring a fuel with 15 ppm sulfur (maximum) and higher volatility than that provided by Grade

1.1 This test method covers the evaluation of the oxidation stability of inhibited steam-turbine oils in the presence of oxygen, water, and copper and iron metals at an elevated temperature. This test method is limited to a maximum testing time of 10 000 h. This test method is also used for testing other oils, such

1.1 This specification covers formulating specifications for purchases of aviation gasoline under contract and is intended primarily for use by purchasing agencies. 1.2 This specification defines specific types of aviation gasolines for civil use. It does not include all gasolines satisfactory for reciprocating aviation engines. Certain equip-ment or conditions of use may permit a wider,

1.1 This terminology standard is a compilation of defini-tions used in the science and technology of the adhesives industry. Terms that are generally understood or adequately defined in other readily available sources are not included. 1.2 Any changes in this standard since 1988 are documented as follows: 1.2.1 Appendix X1 gives a history of revisions