ASTM Standards

1.1 This practice covers the use of a refractometer for determining the nonvolatile matter (total solids) in floor polishes. This practice is also applicable to resin solutions and wax emulsions used in floor polishes.

1.1 This specification covers technical and vapor degreasing grade trichloroethylene. N OTE 1—Guide D3844, Practice D4276, and MNL2 2 provide additional important information on vapor degreasing and solvent properties.

1.1 This practice covers and provides a framework for the Original Equipment Manufacturer (OEM) evaluation and ap-proval of new fuels and new fuel additives for use in commercial and military aviation gas turbine engines. The practice was developed as a guide by the aviation gas-turbine engine Original Equipment Manufacturers (OEMs) with ASTM International member support.

1.1 This guide provides guidelines for several techniques of measuring the foam stability of light-duty hand dishwashing detergent products in the presence of arifially applied lest-food soils. It is intended as a laboralory screening lest to aid in the formulation of products, for quality control and as a basis berween the formulator and supplier in

1.1 This test method describes a method of measuring the shear modulus and rupture stress in shear of adhesives in bonded joints. The method employs lap-shear specimens with wood, metal, or composite adherends, with adhesives having shear moduli ranging up to 700 MPa (100 000 psi). This test method is suitable generally for joints in

1.1 This practice provides a guide to selection of specimens for appearance measurement by reflected light as well as a discussion of factors to be considered in their preparation for measurement. Standardized selection and presentation proce-dures will assist in achieving agreement between evaluations carried out in different  laboratories as well as helping to achieve better

1.1 This test method covers the determination of bow and skew of filling yarns in woven fabrics and the courses in knitted fabrics. 1.2 This test method can also be used to measure the bow and skew of printed geometric designs.

1.1 This practice establishes minimum qualifications for agencies engaged in the testing and inspection ofsoil and rock.Minimum requirements for field and laboratory personnel are defined. The practice also covers the establishment and main-tenance of a quality system.